See our new Electrical test further down on the page
The Porsche 964/993 back spoiler mechanism is equipped with a ball bearing that will fail over time due to moisture and corrosion. A damaged bearing will be heard as a grinding noise or rattle when the spoiler move either up or down. A new bearing is very cheap compared to changing the complete gear mechanism.
Remove two screws and undo the plastic fasteners on the outside. Remove the three hex screws. Remove the splitted plastic ring. It is easy to get to the different components in the spoiler mechanism, all of them are mounted under a plastic cover mounted on the engine lid. Two screws and three plastic retainers hold it in place.
The motor and gear housing are connected with a wire, and this must be removed to be able to detach the gear. Pull off the rubber cap and loosen the white plastic ring with a small screwdriver. This ring is splitted and easy to pull out from the motor housing. Detach the gear housing by removing the three umbraco screws.
Open the glued gear housing. The plastic cover is made of two pieces and these are glued together. Work around the edge with a spatula or knife until the top half comes off. This may take some force.
Clean the gears with alcohol or similar. Remember to clean the connecting wire to the motor as well.
Worm gear axle disassembly
Hang the axle loosely in a vice and punch through the square sleeve.The ball bearing must be pressed off the axle. The easiest way is to hit the axle with a punch or similar while the whole assembly hangs loosely in a vice. Be sure to use a thin and long enough punch so the square metal sleeve is not damaged. You must not hit the metal sleeve, only the axle inside it.
The new ball bearing should be of a more sturdy sealed type, and it can be bought on eBay or ball bearing shops. It is a standard 16x5x5mm bearing, often called 625-2RS or 625DD.
The bearing must be pressed onto the axle until seated against the flange. This can be done by using a brass tube or similar and press it on in a vice. Be sure to press fit the square metal sleeve onto the axle as well.
Grease on all components in the gear as well as the connecting wire and glue the casing halves with Araldite or other slow-curing two-component glue. Please note: Cyancrolate super glue will not stand up to the mechanical stress in the casing.
Voilá, job done in 30 minutes, almost no cash spent! A high-quality sealed 625-2RS ball bearing can be found in our web shop.
Here we describe how to test the rear spoiler power supply, motor and switches.
Remove spoiler control unit, measure with voltmeter on harness connector, pin numbers is printed on the harness connector:
Centre console manual operation switches
Measure with ohmmeter
Mechanism end switches
Measure with ohmmeter, see picture for microswitch placement, red arrows
Motor output test, voltmeter
Connect the control unit to the harness connector. Remove the harness connector top lid. Be very careful to not pull the wires, the pins can easily be removed from the connector. Having the control unit inserted helps holding the pins in place. Connect the voltmeter to pins 3 and 4 (motor output)